Check Vesper GPS Ephemeris Data

Check Vesper GPS Ephemeris Data

Check Vesper GPS  Ephemeris Data

  1. Power on Vesper
  2. Power on Vision GCS
  3. Make sure the aircraft has connected to Vision
  4. Tap the GPS Status Icon at the top of the Vision screen
  5. Confirm that more than 10 satellites are in view
  6. Confirm HDOP is less than 0.09

    • Related Articles

    • Vesper First Flight Guide

      The following guide is a recommended checklist to consider before your first flight with Vesper. Please review this document and familiarize yourself with the steps described and make them part of your first and subsequent flights with Vesper. ...

    • How to enable or disable Vesper Flight Data Logging

      Flight data are stored in Vesper's internal memory when the "Vehicle Flight Logging" parameter is enabled. The instructions below provide operators with instructions about either enabling or disabling Vesper flight data logging. Note: Enabling ...

    • How to Change or Check units

      Change or check units Power up Vesper and Vision GCS. Log in to Vision if necessary Tap the “Q” at the top left of the Vision screen Tap “Settings” Tap “General” Select “Distance” units from the associated drop-down menu Select “Area” units from the ...

    • Vesper Battery Update Instructions

      Vesper Batteries have firmware installed that enables the battery to properly charge and discharge for the best battery life and performance. The version of the battery firmware is checked by Vesper during the boot-up process. If Vesper determines ...

    • Updating Vesper Firmware

      Requirements prior to starting Vesper and accompanying MicroSD card Vesper battery charged > 30% Computer / laptop with internet access to download firmware Time, process may take up to 30 minutes Part I: Prepare MicroSD card Remove MicroSD card from ...